Channel Estimation in MIMO-OFDM System

Authors

  • SR Aryal Institute of Engineering, Tribhuvan University, Pulchowk Campus, Lalitpur
  • H Dhungana Institute of Engineering, Tribhuvan University, Pulchowk Campus, Lalitpur

DOI:

https://doi.org/10.3126/njst.v14i2.10421

Keywords:

mean square error, symbol error rate, least square error, minimum mean square error, Bit error rate

Abstract

There are no limit of human desire, so day by day we need much higher data speed to facilitate our need but every physical resource like frequency band, transmit signal strength are finite. Within the given limited resource, higher data speed is accomplished by new proficiency called Multiple Input Multiple Output (MIMO), Orthogonal Frequency Division Multiplexing (OFDM) system. MIMO-OFDM fulfills the high data rate requirement through spatial multiplexing gain and improved link reliability due to antenna diversity gain. With this technique, both interference reduction and maximum diversity gain are achieved by increasing number of antennae on either side. Received signal in MIMO-OFDM system is usually distorted by multipath fading. In order to recover the transmitted signal correctly, channel effect must be estimated and repaired at receiver. In this paper the performance evaluating parameter mean square error and symbol error rate of least square error, minimum mean square error and DFT based channel estimation methods are estimated and appropriate solution is recommended. Furthermore, comparison among their characteristics is simulated in MATLAB and useful conclusion is delineated.

DOI: http://dx.doi.org/10.3126/njst.v14i2.10421  

Nepal Journal of Science and Technology Vol. 14, No. 2 (2013) 97-102

Downloads

Download data is not yet available.
Abstract
862
PDF
1465

Downloads

Published

2014-05-15

How to Cite

Aryal, S., & Dhungana, H. (2014). Channel Estimation in MIMO-OFDM System. Nepal Journal of Science and Technology, 14(2), 97–102. https://doi.org/10.3126/njst.v14i2.10421

Issue

Section

Articles